1.6.3 - RS232 Cable Installation Guide

To connect the VS 2030 to your host computer via RS232 interface:

1.Make sure the RS232 cable is sufficiently attached to your unit.

2.Connect the RS232 interface cable to your host computer. If you are unsure of the proper location to connect the RS232 cable please consult the manual of your host computer.

3.The RS232 interface is supplied with a power supply. Plug the power supply adapter into the RS232 interface cable and then plug the power adapter into a wall socket.

If you are using the RS232 interface and utilizing Batch functionality, please read the Important Note in batch section. If you are using the 1950 mAH battery for batch mode, the RS232 cable will recharge the VS 2030 battery only if the RS232 cable has a power supply connected and the power supply is plugged into a socket.

4.The VS 2030 will power on automatically.

5.Scan the RS232 One Way Mode code then the Save Settings code to configure reader:

RS232 One Way Mode

Save Settings

RS232 Factory Default Settings

 

 

Mode: RS232 One Way Mode

 

 

Baud Rate: 57600

 

 

Stop Bits:

2

 

 

Data Bits:

8

 

 

Parity: None

6.Your VS 2030 unit should be ready for use. Open the application on your host computer that will receive scanned data and begin scanning.

Warning: Videk, Inc.-approved power adapter must be used. Reader failure due to use of incorrect power adapter will void all warranties.

Save Settings

K11020 VisionSensor™ 2030 User Manual, Rev. E, Software ver. 3.1.1000, August 3, 2007 - 10

 

Page 16
Image 16
Videk 2030 manual RS232 Cable Installation Guide, RS232 One Way Mode Save Settings, Mode RS232 One Way Mode, Baud Rate