Viper Preparation For Use, Measurement Setting, VIPER VR-6000SPECIFICATIONS, General

INSTRUCTIONS MANUAL

MEASUREMENT SETTING

When power is turned on to your new VIPER VR-6000, the keypad display will show the gas weight in the service tank. The display can be set to read in either metric or standard measurements, proceed as follows:

•Switch off the VR-6000.

•Press the SEL, GO, and ENTER keys simultaneously while turning on the VR-6000. The machine will change from one system of units of measurement to the other.

VIPER VR-6000 SPECIFICATIONS

Electrical Input:	115 Vac, 8 A, 60 Hz
Ambient Operating Temperature Range:	50° F (10° C) to 120° F (48.9° C)
Approximate Shipping Weights:	170 lbs.

PREPARATION FOR USE

GENERAL

Your VIPER VR-6000 Air Conditioning Service Center is shipped completely assembled and 100% pre-tested. Your VIPER VR-6000 needs to be prepared before it can be used to service a vehicle's air conditioning system.

PREPARATION

The following steps, for the most part, are used only to prepare your VR-6000 for operation.

1.Remove the shipping carton.

2.Lift out the VR-6000 from the pallet to the ground.

3.Loosen the scale hand screw (see Figure 9) that is under the scale platform. It is tightened to prevent damage to the scale during shipment. Turn counter clockwise six full turns. Note: If you do not loosen the scale hand screw under the scale platform, the scale will remain inoperab le.

13