S I M P L E
ENGINEERING MODE
Engineering mode consists of six optional settings. Use the engineering mode to access information and enable certain features or displays on your console.
ENTERING AND USING ENGINEERING MODE
•Press and hold the UP ▲ and DOWN ▼ keys for approximately three seconds.
•The console will beep and display engineering modes and optional settings. Use the UP ▲ or DOWN ▼ keys to scroll through the options. Press the ENTER key to select the appropriate mode or setting.
OPTIONALSETTINGS
S E T T I N G
ENG1 – LCD TEST
ENG2 – HARDWARE TEST
ENG2 – ACCUMULATED TIME/
ACCUMULATED DISTANCE
ENG3 – MACHINE AND
UNITS MODE
ENG4 – DEFAULT TIME SET
ENG5 – DEFAULT LEVEL SET
ENG6 – PRODUCT SELECTION AND MODEL CONFIGURATION
D E S C R I P T I O N
TEST USED BY SERVICE TECHNICIANS TO TEST LCD DISPLAYS
TEST USED BY SERVICE TECHNICIANS TO TEST EDDIE CURRENT BRAKE SYSTEM
MEASURES TOTAL TIME USED IN HOURS AND MEASURES TOTAL DISTANCE USED IN MILES
USED BY SERVICE TECHNICIANS TO CHECK IF THE CONSOLE IS SET TO BIKE MODE OR ELLIPTICAL MODE, SHOWS YOU IF THE EXERCISE FEEDBACK IS SET TO THE ENGLISH (MILES) OR METRIC (KILOMETERS) SYSTEM AND DISPLAYS THE SOFTWARE VERSION
ALLOWS YOU TO SET THE TIME THAT THE COMPUTER WILL DEFAULT TO FOR ALL PROGRAMS
ALLOWS YOU TO SET THE LEVEL THAT THE COMPUTER WILL DEFAULT TO FOR ALL PROGRAMS
ALLOWS YOU TO CONFIGURE YOUR CONSOLE TO THE PROPER PRODUCT (BIKE OR ELLIPTICAL)ANDMODELNUMBERIFITWASNOTDONECORRECTLYINTHEINITIALSETUP
• Use the UP ▲ and DOWN ▼ keys within each setting to change the setting.
28• Press the ENTER key to save settings.
• To EXIT engineering mode, press and hold the START key for three seconds.
