Physical Description
Front Panel
Status LED’s
NET | SYS |
Tx/Rx | Power |
Link | LED1 |
10/100 | (Heartbeat) |
Full duplex | LED2 |
| (Status) |
Each time Video Server starts up, it will perform power-on-self-test, abbreviated as POST, to examine every hardware module. As soon as the administrator plugs in the power connector both LED’s under the power LED will flash one by one until the diagnosis is done. If the result is good, both status LED’s will turn off for a while and then follows the pattern below. If any module fails, refer to the Appendix A for the error pattern and follow the trouble-shooting procedures. If the system still cannot operate normally, please contact your reseller for technical service.
- 8 -
www.vivotek.com
