Getting connected cont.

Connecting to a 2-Channel Stereo Receiver/Mixer/TV

When connecting to the 2-channel L/R audio inputs on a stereo receiver or TV, the DVG-909K gives you the option of outputting both disc players independently or together through the Mixed audio output.

Connecting each disc player independently (Fig. A)

Connect your L/R RCA cables to the L and R AUDIO outputs on the rear panel of the DVG-909K to the L/R (red and white) audio inputs on your 2-channel stereo receiver, mixer or TV. See figure. A

NOTE: Depending on the stereo receiver/TV, the audio input jacks may be labeled AUDIO, LINE, AUX, AV 1, etc.

Connect the disc players together using the Switched Output (Fig. B)

Connect your L/R RCA cables to the L and R MIX AUDIO OUT on the rear panel of the DVG-909K. Connect the other end of your cables to the L/R (red and white) audio inputs on your 2-channel stereo receiver, mixer or TV. See figure. B

NOTE: When using the Switched Output, the DVG-909K will automatically switch the audio output to the active disc player A or B.

2-Channel/DTS

B

KJ-7800 PRO

DTX-5000G

LTV-5

(Fig. A)

(Fig. B)

(Fig. C)

Connecting to a DTS Receiver/Decoder (Fig. C)

Using either an RCA-ended COAXIAL cable suited for digital audio or an OPTICAL cable, connect one end to the appropri- ate jack on the DVG-909K (Coaxial or Optical) and the other end to the appropriate jack on the DTS receiver (Coaxial or Optical).

NOTE: If you have both coaxial and optical inputs on your DTS decoder/receiver, it is recommended that you use an optical connection as those cables eliminate the possibility of EMI (electromagnetic interference). If your DTS receiver does not have a built-in DTS decoder, and has 5.1 channel RCA inputs, you can use the 5.1 channel output jacks on the DVG-909K. Either method will provide for DTS decoding.

9

Page 10
Image 10
VocoPro DVG-909K owner manual Channel/DTS KJ-7800 PRO DTX-5000G, Connecting to a 2-Channel Stereo Receiver/Mixer/TV