VTech VT 2960 Audible Message Alert, R e s s S T O P / P L AY t o e x i t programming mode

THE VT2960 ANSWERING SYSTEM

AUDIBLE MESSAGE ALERT

This feature provides a beep tone from the Base Unit at approximately 10 second intervals, alerting you to new, unplayed messages. To program Audible Message Alert:

1.Press MENU three times. Voice prompt says, " S e t Au d i bl e Message Alert."

2.Press SELECT to choose "ON" or "OFF".

3.Press TIME/SET to confirm your selection. ("Audible Message Alert is ____")

4.Press MENU to advance to the next programming function, or press STOP/PLAY to exit programming mode .

SELECT button down will increase the minute setting by increments of 10.

7.Press TIME/SET. Voice prompt will announce the current day and time.

8. P r e s s S T O P / P L AY t o e x i t programming mode.

		SETTING THE DAY AND TIME
	MENU	PRESS MENU FOUR TIMES
VT 2960	SELECT	FOR "SET DAY AND TIME".
	TIME/SET	PRESS SELECT TO CHOOSE
		THE CORRECT DAY.
L2	MSG	PRESS TIME/SET TO CONFIRM.
	MSG
ANSWER
	SELECT
L1
MSG
ANSWER		PRESS SELECT TO CHOOSE
STOP/PLAY	ON/OFF
SKIP
	MEMO	THE CORRECT HOUR.
	RECORD/
VOLUME		PRESS TIME/SET TO CONFIRM.
HOLD MUTE	CONF.	PRESS SELECT TO CHOOSE
		THE CORRECT MINUTE.
LINE 2	OFF

PRESS TIME/SET TO CONFIRM.

PRESS STOP/PLAY TO EXIT

PROGRAMMING.

		MENU
	VT 2960	SELECT
		TIME/SET
	L2	MSG
		MSG
	ANSWER	SELECT
	L1
	MSG
	ANSWER
AT	STOP/PLAY	ON/OFF
	SKIP
		RECORD/
		MEMO

VOLUME

AUDIBLE MESSAGE ALERT

PRESS MENU THREE TIMES FOR "SET AUDIBLE MESSAGE ALERT"

PRESS SELECT TO CHOOSE ON OR OFF.

PRESS TIME/SET TO CONFIRM SELECTION.

BASIC ANSWERING SYSTEM OPERATION

T U R N I N G T H E A N S W E R I N G SYSTEM ON AND OFF

As you press the ON/OFF button repeatedly, the voice prompt goes through the following sequence, and

HOLD MUTE CONF.

LINE 2 OFF

SETTING THE DAY AND TIME

1.Press MENU four times until voice prompt says, "Set Day and Time."

2.Press SELECT to choose the correct day.

3.Press TIME/SET. Voice prompt will announce an hour setting.

4.Press SELECT until you reach the correct hour.

5.Press TIME/SET. Voice prompt will announce a minute setting.

6.Press SELECT until you reach the correct minute. Holding the

the corresponding L1 ANSWER and

L2 ANSWER indicators will illuminate: "Answering Machine ON for Both Lines"

"Answering Machine ON for Line 1, OFF for Line 2"

"Answering Machine OFF for Line 1, ON for Line 2"

"Answering Machine OFF for Both Lines"

NOTE:If L1 Answer and/or L2 Answer indicators are flashing, it is to remind you that the system is in the Announce - Only mode for that particular line(s).

33