VTech VT 2960 instruction manual Wall Mounting, Position the wall mounting bracket on the Base

WALL MOUNTING

The Wall Mount bracket is designed to fit on standard Wall Mount plates.

1.Choose a spot near an electrical outlet and a telephone jack.

Your phone requires a modular tel- ephone jack and a standard electri- cal outlet (120v AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the Base. The outlet should not be con- trolled by a wall switch. If the switch is ever turned off, the phone will not operate. (Unless you have a power back-up battery)

2.Position the wall mounting bracket on the Base.

Line up the tabs on the wall mount- ing adaptor with the holes on the bot- tom of the base (Figure 1). Snap the wall mounting adaptor firmly in place.

3.Mount the Base on the wall. Position the Base so the mounting studs will fit into the holes on the bottom of the Base. Position the power cord to extend down the wall the phone is to be mounted on. Slide the base down on the mounting studs until it locks into place.

4.Connect the telephone cord. The telephone line cord has a snap- in plug at each end. Insert one of the plugs into the jack on the back of the Base. Insert the other end of the plug into the wall jack.

5. Plug the AC adaptor into an elec- trical outlet and the DC connecter into the power jcak located on the back of the Base Unit (Figure 2).

PULSE

TONE

Figure 1

2	12						SELECT
3	13						TIME/SET
4	14
		POWER
5	15
6	16	CHARGING
7	17
8	18					L2
9	19	SPARE BATTERY					MSG
							MSG
10	20						SELECT
					L1	ANSWER
					MSG
				ANSWER
		ERASE	REPEAT		STOP/PLAY	SKIP	ON/OFF
							RECORD/
							MEMO
					VOLUME
		INT.COM		HOLD	MUTE		CONF.
		LINE 1			LINE 2		OFF

Figure 2

8