Wacom DTU-1931 user manual LCD Monitor Installation, Apple ADC Connector Mini-VGA port

DTU193_Manual.fm Page 12 Monday, September 15, 2008 2:42 PM

STEP1: LCD MONITOR INSTALLATION

In this step, the DTU-1931 is installed as a monitor on your system.

IMPORTANT: Do not connect the USB data cable until instructed to do so.

•Turn off your computer.

Caution: Never connect or disconnect the video or power cables while your computer or DTU-1931 are powered on – this can damage the display or video card.

•If your computer has only one video connector, you will need to unplug your previous monitor or add a second video card. Determine if your computer has an analog (VGA) or digital (DVI) connector and set the DVI/VGA switch for the video connection you are using. See – A – in the connection diagram on page 13.

•Making sure to tighten the thumbscrews on the connectors, follow the instructions below for your video connector. See – B –

	For DVI operation, connect the DTU-1931 DVI to DVI video cable between the
DVI-I connector	DVI IN connector located on the pen display unit and the DVI-D or DVI-I
	connector on your video card.
DVI-D connector
	For VGA operation, connect the DTU-1931analog RGB video cable between the
VGA connector	DVI IN connector located on the pen display unit and the VGA connector on your
	video card.

Apple ADC

connector

Mini-VGA port

If connecting to an Apple ADC or mini-VGA connection, you will need to obtain an appropriate adapter. Adapters can be purchased at various retail outlets.

For ADC operation, plug one end of the DTU-1931 DVI to DVI video cable into the ADC to DVI adapter. Then connect the other end of the DTU-1931 cable to the DVI IN connector on the pen display unit. Next connect the ADC adapter end to the ADC connector on your video card.

For an Apple mini-VGA connector, plug the VGA end of the DTU-1931 analog RGB cable into the mini-VGA port adapter. Then connect the DVI end of the DTU-1931 cable to the DVI IN connector on the pen display unit. Next connect the mini-VGA port end to the mini-VGA port on your video card.

•Connect the power adapter to the DTU-1931. See – C – on the next page.

•Then connect the adapter’s power cable and plug the adapter into an AC outlet. See – D –

•Turn on the DTU-1931. The power LED will light orange.

Installation

Page 12