Wacom DTU-1931 user manual Using AN Alternate Mount or Stand

DTU193_Manual.fm Page 40 Monday, September 15, 2008 2:42 PM

USING AN ALTERNATE MOUNT OR STAND

If you will be using the DTU-1931 in an installation that requires the use of an alternate mounting platform, you can remove the adjustable stand from the unit and mount the pen display onto any mount arm or stand conforming to the VESA 100 mm standard.

Mounting screws that are 4 mm wide with a 0.7 mm pitch (M4 Regular), with a screw clearance depth of 15 mm are required. Exceeding the clearance depth of 15 mm will damage the pen display internal components.

To remove the adjustable stand and attach the pen display to a different mounting platform:

1.Turn off your computer and power off the DTU-1931. Then disconnect all

cables from between the unit and your computer.

2. Protect the display screen surface by

spreading a soft cloth onto a flat table and placing the DTU-1931 face down on the cloth.

3. Remove the four screws and lift the adjustable stand assembly away from the body of the unit.

4. Using the appropriate screws for your mounting platform, firmly attach the DTU-1931 to the alternate mounting platform.

5. Refer to the Installation instructions, beginning on page 11, and reattach the cabling.

CAUTION

When attaching the DTU-1931 onto an alternate mounting platform, be sure to follow all instructions in the documentation supplied by the platform manufacturer. If improperly installed, the unit could fall, resulting in damage to the unit or physical injury.

Appendix

Page 40