Wacom DTU-1931 user manual LCD Monitor Cabling Diagram

DTU193_Manual.fm Page 13 Monday, September 15, 2008 2:42 PM

LCD MONITOR CABLING DIAGRAM

CAUTION

Make sure your video card has a VGA or DVI connector, and that you correctly set the DVI/VGA switch for the video connector you are using.

Do not attach the USB data cable until instructed to do so.

VGA or DVI		– A –	Analog (VGA)
video card	DVI/VGA switch		Digital (DVI)

Rear panel		
of computer	– B –

Analog RGB cable

or

DVI to DVI cable

– C –

DC input

To AC outlet

– D – Power adapter

CAUTION

Use the DVI-I OUT port to connect a second device, such as a projector or monitor, that mirrors the pen display.

Fully install the DTU-1931 hardware and software before connecting a projection device to the unit.

DVI IN

Do not connect or disconnect the video or power cables while the DTU-1931 or your computer are turned on – this can damage the display or computer video card.

Use only the power adapter that came with the DTU-1931; use of an improper power adapter may

damage the unit.

Make sure that the display refresh rate does not exceed 75 Hz.



Installation

Page 13