Manuals / Wayne-Dalton / Household Appliance / Water Pump

Wayne-Dalton 9700 installation instructions Stacking Sections - Continued, U-Bar

Models: 9700

1 32

Page 11

	Stacking Sections - Continued
Tools Needed:
		(3) 1/4” - 14 x 5/8”
		SELF-TAPPING SCREWS
		Intermediate hinges
8	U-Bar	U-Bar
		U-Bar

Tools Needed:	NOTE: For door section identification see
Power Drill	page 4.
Power Drill
7/16” Socket	NOTE: 18’-0” wide by 8’-0” high doors
Driver	will be supplied with one u-bar for the lock	Lock section
Tape Measure	section.	Edge
Tape Measure

Center the u-bar on top edge of lock section and flush with edge of section. Fasten each end of the u-bar to the endcap with

1/4” - 14 x 7/8” self tapping screws at 30” - 36” inches (762 mm - 914 mm) intervals across the section.

30” - 36”	Lock section
1/4” - 14 x 7/8”	U-bar
SELF TAPPING SCREWS	U-bar

	Attaching ends and center of u-Bar

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your		11
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Page 11

Image 11

Wayne-Dalton 9700 installation instructions Stacking Sections - Continued, U-Bar

Contents

Torquemaster Plus - Single and Double Spring 9700Definition of key words used in this manual Table of ContentsPackage Contents Door Section Identification Removing An Existing Door Tools Requiredmust be replaced Preparing the OpeningIMPORTANT Closely inspect jambs, header and mounting surface. Any wood found not to be soundTools Needed None InstallationTracks Attaching Flagangles to VerticalTools Needed Hammer Installing Jamb BracketsHorizontal Angles Tools Needed None DrumsBottom Section 7/16” Socket Driver Tape Measure Level Tools Needed 3/16” Drill Bit Power DrillVertical Tracks Stacking SectionsU-Bar Stacking Sections - ContinuedOperator Bracket Top Section Top BracketsDO NOT RAISE DOOR UNTIL FlaganglesDO NOT RAISE DOOR UNTIL INJURYTools Needed 7/16” Wrench Step Ladder Adjusting Top BracketsTorqueMaster Spring Tube Center Bracket Bushing 1-1/2Wraps Cable Drums/ Drum Wraps7/16” Wrench 7/16” Socket Driver Step Ladder AssemblyEnd Brackets Securing Center BracketIMPORTANT ENSURE THE CABLE IS Cable AdjustmentSecuring Door for Spring Winding Tools Needed 2 Vice Clampswinding the TorqueMaster Winding Springsit is recommended that leather gloves be worn whileIMPORTANT Mark number of spring Winding Springs ContinuedSecuring Drum Wraps Tools Neededcause severe or fatal injury Rear SupportRaising door further can result in door falling andFULL TENSION OF THE SPRING SPRING TURN CHARTRear Support Continued Instructions TorqueMaster Plus ResetTools Needed TorqueMaster Plus Reset Instructions ContinuedPlace vice clamps TorqueMaster Plus Reset Instructions ContinuedTools Needed ON DOORS WITH ELECTRIC DO NOT INSTALL PULL ROPESPower Drill Pull RopeOPERATOR MUST BE TESTED AT TIME OF INSTALLATION AND MONTHLYINSTALLATION INSTRUCTIONS AND Trolley OperatorPainting CleaningPainting Continued Lifetime Limited Warranty Model Thank you for your purchase Please Do Not Return This Product To The Store