Manuals / Wayne-Dalton / Household Appliance / Water Pump

Wayne-Dalton 9700 On Doors With Electric, Fatal Injury, Do Not Install Pull Ropes

Models: 9700

1 32

Page 27

❉		Pull Rope
		Pull Rope


Tools Needed:		WARNING
Tools Needed:
Power Drill
Power Drill	DO NOT INSTALL PULL ROPES
1/8” Drill Bit	DO NOT INSTALL PULL ROPES
1/8” Drill Bit	ON DOORS WITH ELECTRIC
Tape Measure	OPERATORS. CHILDREN MAY
	BECOME ENTANGLED IN THE
	ROPE CAUSING SEVERE OR
	FATAL INJURY.
	Screw the No. 6 screw eye into the wood
	jamb approximately 48” to 50” (1220 to
	1270 mm) from the floor. Tie the pull rope
	to the screw eye and to the bottom bracket
	as shown.

NO. 6 SCEW EYE

PULL ROPE

BOTTOM BRACKET

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your	27
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Page 27

Image 27

Wayne-Dalton 9700 On Doors With Electric, Fatal Injury, Do Not Install Pull Ropes, Power Drill

Contents

Torquemaster Plus - Single and Double Spring 9700Definition of key words used in this manual Table of ContentsPackage Contents Door Section Identification Removing An Existing Door Tools Requiredmust be replaced Preparing the OpeningIMPORTANT Closely inspect jambs, header and mounting surface. Any wood found not to be soundTools Needed None InstallationTracks Attaching Flagangles to VerticalInstalling Jamb Brackets Horizontal AnglesTools Needed Hammer Drums Bottom SectionTools Needed None 7/16” Socket Driver Tape Measure Level Tools Needed 3/16” Drill Bit Power DrillVertical Tracks Stacking SectionsU-Bar Stacking Sections - ContinuedOperator Bracket Top Section Top BracketsDO NOT RAISE DOOR UNTIL FlaganglesDO NOT RAISE DOOR UNTIL INJURYAdjusting Top Brackets TorqueMaster Spring TubeTools Needed 7/16” Wrench Step Ladder Center Bracket Bushing 1-1/2Wraps Cable Drums/ Drum Wraps7/16” Wrench 7/16” Socket Driver Step Ladder AssemblyEnd Brackets Securing Center BracketIMPORTANT ENSURE THE CABLE IS Cable AdjustmentSecuring Door for Spring Winding Tools Needed 2 Vice Clampswinding the TorqueMaster Winding Springsit is recommended that leather gloves be worn whileIMPORTANT Mark number of spring Winding Springs ContinuedSecuring Drum Wraps Tools Neededcause severe or fatal injury Rear SupportRaising door further can result in door falling andSPRING TURN CHART Rear Support ContinuedFULL TENSION OF THE SPRING Instructions TorqueMaster Plus ResetTools Needed TorqueMaster Plus Reset Instructions ContinuedTorqueMaster Plus Reset Instructions Continued Tools NeededPlace vice clamps ON DOORS WITH ELECTRIC DO NOT INSTALL PULL ROPESPower Drill Pull RopeOPERATOR MUST BE TESTED AT TIME OF INSTALLATION AND MONTHLYINSTALLATION INSTRUCTIONS AND Trolley OperatorPainting CleaningPainting Continued Lifetime Limited Warranty Model Thank you for your purchase Please Do Not Return This Product To The Store

Pull Rope

DO NOT INSTALL PULL ROPES

ON DOORS WITH ELECTRIC

FATAL INJURY.