| Winding Springs Continued... |
|
|
|
Tools Needed: | For double spring applications: | Back of torquemaster® | plus end bracket warning tag | |
|
|
| ||
Either use the black tooth on the ratchet wheel |
|
|
| |
|
|
|
| |
| for winding or place a mark on the winding |
|
|
|
| shaft and end bracket. Place the ratchet with |
|
|
|
| 5/8” socket onto the left hand winding shaft |
|
|
|
| end. To wind the spring, rotate the winding | Spring Turns |
| |
| shaft clockwise, while watching the black | Door Height | Spring Turns |
|
| tooth on the ratchet wheel or the mark on the | (6’ - 0”) | 14 |
|
| winding shaft. Rotate the winding shaft to the | (6’ - 3”) | 14 - 1/2 |
|
| (6’ - 5”) | 15 |
| |
| required number of turns for your door. Then |
| ||
| (6’ - 6”) | 15 |
| |
| return to the right hand side and wind the right |
| ||
| (6’ - 8”) | 15 - 1/2 |
| |
| hand spring to the required number of turns. | (6’ - 9”) | 15 - 1/2 |
|
| Place pawl knob in lower position on both | (7’ - 0”) | 16 |
|
| sides. | (7’ - 3”) | 16 - 1/2 |
|
|
| (7’ - 6”) | 17 |
|
| IMPORTANT: Mark number of spring | (7’ - 9”) | 17 - 1/2 |
|
| (8’ - 0”) | 18 |
| |
| turns on TorqueMaster® Plus end bracket |
| ||
|
|
|
| |
| warning tag. | Number of Installed Spring Turns | Location for | |
| NOTE: Since total turns to balance door can | |||
|
|
| marking number | |
| deviate from spring turn chart values by |
|
| of installed |
| ± 1/2 turn, adjustments to the recommended |
|
| spring turns |
| number of turns may be required after rear |
|
|
|
| hangers assembly is completed. |
|
|
|
IMPORTANT! Hold the door down to prevent it from rising unexpectedly in the event the spring was overwound and cautiously remove vICE cLAMPS from vertical tracks.
22 | Last Rib | Drum Wrap Cable Drum |
| ||
| Securing Drum Wraps |
|
Tools Needed: |
| |
Step Ladder | rotate down. |
|
|
|
IMPORTANT: PULL THE COUNTERBALANCE
CABLE AWAY FROM THE HEADER TO CLEAR
THE LATCH. SIMULTANEOUSLY SLIDE THE
DRUM WRAP AGAINST THE LAST RIB UNTIL
THE THREE CATCHES ENGAGE THE 3RD RIB.
Counterbalance Cable |
| ||
Pull to clear latch |
| ||
until a distinct snap is felt. |
| ||
Hinged |
| ||
|
| ||
Confirm the catch is fully engaged by lightly | Latch |
| |
3 Catches | 3rd Rib | ||
tugging on it. |
Repeat for the left hand side.
Secure |
|
Hinged Latch |
|
Please Do Not Return This Product To The Store. Contact your local | 21 |
local yellow pages business listings or go to the Find a Dealer section online at |
|