Wayne-Dalton 9700 Flagangles, Do Not Raise Door Until, Injury, Attaching Horizontal Tracks to

12	Attaching Horizontal Tracks to
	Flagangles
Tools Needed:	If you have fully adjustable flagangles:
9/16” Socket	To install horizontal track, place the curved
	end over the top roller. Align the bottom of
7/16” Socket	the horizontal track with the vertical track.
Ratchet Wrench	Hand tighten the horizontal track to the
	flagangle with (2) 1/4”-20 x 9/16” track
9/16” Wrench	bolts and (2) 1/4” - 20 flange hex nuts.
Level	Repeat for other side.
	WARNING
Step Ladder

DO NOT RAISE DOOR UNTIL

HORIZONTAL TRACKS ARE SE­

CURED AT REAR, AS OUTLINED

IN STEP 23, OR DOOR COULD

FALL FROM OVERHEAD POSI­

TION CAUSING SEVERE OR FATAL

INJURY.

Level the horizontal track assembly and bolt the horizontal angle to the slot in the flagangle using (1) 3/8” - 16 x 3/4” truss head bolt and (1) 3/8” - 16 hex nut. Repeat for other side.

NOTE: If an idrive® opener will be installed, position horizontal tracks slightly above level.

Remove the nail that was temporarily holding the top section in place, installed in Step 11.

IMPORTANT: Failure to remove nail before attempting to raise door could cause permanent damage to top section.

If you have quick install flagangles: Align key slot of the horizontal track with the quick install tab of the flagangle. Push curved portion of horizontal track down to lock in place.

WARNING

DO NOT RAISE DOOR UNTIL

HORIZONTAL TRACKS ARE SE­

CURED AT REAR, AS OUTLINED

IN STEP 23, OR DOOR COULD

FALL FROM OVERHEAD POSI­

TION CAUSING SEVERE OR FATAL

INJURY.

Level the horizontal track assembly and bolt the horizontal angle to the slot in the flagangle using (1) 3/8” - 16 x 3/4” truss head bolt and (1) 3/8” - 16 hex nut. Repeat for other side.

NOTE: If an idrive® opener will be installed, position horizontal tracks slightly above level.

Remove the nail that was temporarily holding the top section in place, installed in Step 11.

IMPORTANT: Failure to remove nail before attempting to raise door could cause permanent damage to top section.

flagangle

HORIZONTAL TRACK

	1/4”-20 x 9/16”
	Track Bolts
1/4”-20 flange
hex nuts	Vertical Track
fully adjustable flagangles
Flagangle	Flagangle
Horizontal	Horizontal
	track
track
Key slot	QUICK
	INSTALL
	TAB
QUICK
INSTALL	Key slot
TAB
Vertical	Vertical
track	track

quick install flagangles

3/8” - 16 X 3/4”

TRUSS HEAD BOLT

3/8” - 16 Hex nut

Horizontal ANGLE

HORIZONTAL TRACK

14Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com