Wayne-Dalton 9700 Securing Door For Spring Winding, Cable Adjustment, Tools Needed Vice Clamps

19

Tools Needed:

(2) Vice Clamps

Securing Door

for Spring Winding

Place vice clamps onto both vertical tracks just above the third Roller. This is to prevent the garage door from raising while winding torsion spring(s).

WARNING

Failure to place vice clamps onto vertical Track can allow door to raise and cause severe or fatal injury.

Place vice

clamps above

3rd Roller

Vice clamps

attached to Track track

20	Cable Adjustment	Cam Peak	First and
			second groove
		Straight Up
Tools Needed:	Starting on the right side, adjust the cable
Vice Grips	drum assembly by rotating the drum until
	the set screw faces directly away from the
Pliers/Wire	header. Torque tube cam peak should be	Cut Cable
	pointing straight up.
Cutters
	Loosen the set screw no more than 1/2 turn.	Here	Set Screw
Flat Tip	Ensure counterbalance cable is aligned and
Screwdriver	seated in the first and second grooves and	6”
	pull on the end of the counterbalance cable
Step Ladder	to remove all cable slack.

Snug the set screw, and then tighten an additional1-1/2 turns. Measure approximately 6” of cable and cut off excess cable. Insert end of cable in hole of cable drum.

Repeat for left hand cable drum assembly.

IMPORTANT: ENSURE THE CABLE IS

ALIGNED AND SEATED IN THE FIRST

AND SECOND GROOVES OF THE CABLE

DRUM PRIOR TO WINDING SPRINGS.

NOTE: This illustration shows the right hand TorqueMaster® Plus cable drum assembly, left hand cable drum assembly is symmetrically opposite.

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your	19
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com