|
| |
9 | Top Section | |
| ||
| Place the top section in the opening | |
Tools Needed: | ||
and vertically align with lower sections. | ||
Hammer | ||
Align vertical lines on the alignment | ||
Step Ladder | stickers located on the right hand side | |
on the back of the door. Temporarily | ||
| ||
| secure the top section by driving a | |
| nail in the header near the center of | |
| the door and bending it over the top | |
| section. | |
| Flip up hinge leafs, hold tight against | |
| section, and fasten center hinges first, | |
| and end hinges last. (Refer to Step 6). | |
| Position wallangle between | |
| (43 mm) to | |
| edge of the door; tighten the bottom lag | |
| screw in the wallangle. Wallangle must | |
| be parallel to the door section. Repeat | |
| for opposite side. | |
| IMPORTANT: THE DIMENSION | |
| BETWEEN THE wallANGLES MUST BE | |
| DOOR WIDTH PLUS | |
| ||
| DOOR OPERATION. | |
| Complete the wallangle assembly | |
| installation by tightening all the lag | |
| screws. Push the vertical track against | |
| the rollers so that the rollers are | |
| touching the deepest part of the curved | |
| side of the track (see illustration); | |
| tighten all the track bolts and nuts. | |
| Repeat for opposite side. | |
|
|
NAIL |
|
Alignment stickers | INSTALLATION |
| |
vERTICAL tRACK |
|
ROLLER |
|
ROLLER Against |
|
VERTICAL TRACK |
|
Fully adjustable Track |
|
WallANGLE |
|
| |
top |
|
SECTION |
|
Please Do Not Return This Product To The Store. Contact your local | 13 |
To find your