Wayne-Dalton 9800 installation instructions Attaching Horizontal Track to, Wall angle

10		Attaching Horizontal Track to
		Wall angle
Tools Needed:	To install horizontal track, place the
9/16” Socket	curved end over the top roller. Align
	the bottom of the horizontal track with
7/16” Socket
	the vertical track. Hand tighten the
Ratchet Wrench	horizontal track to the wallangle with
9/16” Wrench	(2) 1/4”-20 x 9/16” track bolts and (2)
	1/4” - 20 flange hex nuts. Repeat for
Level
	other side.
Step Ladder
		WARNING
	DO NOT RAISE DOOR UNTIL
	HORIZONTAL TRACKS ARE SECURED­
	AT REAR, AS OUTLINED IN STEP 19, OR
	DOOR COULD FALL FROM OVERHEAD
	POSITION­ CAUSING SEVERE OR FATAL
	INJURY.
	Level the horizontal track assembly and
	bolt the horizontal angle to the slot in
	the wallangle using (1) 3/8” - 16 x 3/4”
	truss head bolt and (1) 3/8” - 16 hex
	nut. Repeat for other side.
	Remove the nail that was temporarily
	holding the top section in place,
	installed in Step 9.
	IMPORTANT: Failure to remove nail
	before attempting to raise door
	could cause permanent damage
	to top section.

wallangle

1/4”-20 x 9/16” Track Bolts

1/4”-20 flange

hex nuts

	3/8” - 16 Hex nut
wallangle
		3/8” - 16 X 3/4”
		TRUSS HEAD BOLT

hORIZONTAL ANGLE

HORIZONTAL

TRACK

14Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com