Wayne-Dalton 9800 Side Lock, Pull Rope, On Doors With Electric, Rope Causing Severe Or

�	Side Lock
Tools Needed:	Attach the side lock striker plate to the
	vertical track, in line with the center of
Power Drill
	the second door section with (2) 1/4”-20
7/16” Socket	x 9/16” track bolts and (2) 1/4”-20 nuts.
Driver	Position the side lock on the second
	section of the door, aligning it with the
	square hole in the side lock striker
	plate. The side lock should be spaced
	approximately 1/8” from the section
	edge. Secure the side lock to the section
	with (4) 1/4”- 20 x 11/16” self drilling
	screws.
	IMPORTANT: side locks must be
	removed or made inoperative in
	the unlocked position if an
	operator is installed on the door.
	NOTE: For windload specification option
	codes 1220 and 1222, the side lock
	striker plate and the fifth door jamb from
	the floor will occupy the same location.
	NOTE: After completing this step,
	continue with step 10 on page 13.

Side lock striker plate	(2) 1/4”-20 x 9/16”
(2) Nuts	Track bolts

1/8”	(4) 1/4”- 20 x 11/16”
	self drilling screws

Side lock assembly

second Section

�	Pull Rope	NO. 6 SCEW EYE
Tools Needed:	WARNING
Power Drill	DO NOT INSTALL PULL ROPES
1/8” Drill Bit	ON DOORS WITH ELECTRIC
	OPERATORS. CHILDREN MAY
	BECOME ENTANGLED IN THE
	ROPE CAUSING SEVERE OR
	FATAL INJURY.	PULL ROPE
	Measure and mark the jamb on the
	right of left side approximately 48” to
	50” (1220 to 1270 mm) from the floor.
	Drill 1/8” pilot hole for No. 6 screw eye.	PULL ROPE
	Tie the pull rope to the No. 6 screw eye

and to the bottom bracket as shown.

	BOTTOM BRACKET
22	Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com