Installation
Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb with header. Side clearance, from edge of door to wall, must be a minimum of
IMPORTANT: Stainless steel or PT 2000 coated lag screws MUST be used when installing center bearing brackets, end brackets, jamb brackets, operator mounting/support brackets and disconnect brackets on treated lumber
NOTE: It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit prior to fastening.
NOTE: Use this manual in conjunction with the windload specification options code provided with your door.
1 | Horizontal Angles |
| HOrizontal Angle |
|
| ||
|
| tab | |
Tools Needed: | Position the horizontal angle as shown. | hole |
|
Hammer | Place tabs of horizontal angle in the key |
|
|
| slots of horizontal track. |
|
|
|
|
| key slot |
| Using a hammer, tap the horizontal |
| horizontal TRACK |
| angle towards the curved end of the | hole | |
| track until the holes in track and angle |
| horizontal |
| are aligned. Set tracks aside. |
| |
|
|
| TRACK |
NOTE: The horizontal angle may be spot welded to the horizontal track. If the horizontal angle is not welded, the horizontal angle will be installed as shown.
HOrizontal Angle | horizontal |
| horizontal |
| TRACK |
| |
|
|
| angle |
|
|
| horizontal |
|
| hole | TRACK |
|
|
| |
|
| aligned |
|
| tab |
|
|
6 | Please Do Not Return This Product To The Store. Contact your local |
To find your