Wayne-Dalton 9800 installation instructions Door Section Identification, Tools Required

	Door Section Identification
Tools Needed:	Hinges are always pre-attached to the top of each
	section (except top section). See illustrations to
	the right.
	The bottom section can be identified by the
	factory attached bottom astragal and by the bottom
	bracket warning labels on each end stile.
	The lock section can be identified by
	section side view.
	The INTERMEDIATE I SECTION can be identified
	by the section side view or by the warning label
	attached to either the right or left hand end stile.
	The INTERMEDIATE II SECTION
	(Not used on a four section door. Used on five
	section doors only) can be identified

Section side views (top of sections shown)

Top

1-9/16”

Intermediate II

(NOt on a four section door, five section door only)

1-3/8”

Intermediate I

warning label (May be on right or left hand side)

by section side view.

The top section can be identified with no pre-

installed end or center hinges on the section and

the warning label attached in the upper middle of

the section.

NOTE: The section side view illustrations show the

Lock

1-1/8”

7/8”

end hinge profile of each section. Only the tops of

the sections are shown. The end hinge profiles can

be used to identify each section.

	Bottom
	Bottom Bracket
astragal	warning Labels

Tools Required

Power Drill Ratchet Wrench Pliers/Wire Cutters Tape Measure 1/8”, 3/16” Drill Bits

Phillips Head Screwdriver Flat Tip Screwdriver Pencil Needle Nose Pliers gLOVES

7/16”, 1/2”, 9/16”		3/8”, 7/16”, 1/2”,	9/16”
Sockets	7/16” Socket Driver	Wrenches	Safety Glasses

Hammer	vice grip	(2)vice clamps	(2)saw horses	Step Ladder
4	Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com