|
| |
11 | Adjusting Top Brackets | |
| ||
|
| |
Tools Needed: | With horizontal tracks installed, you can | |
Power Drill | now adjust the top brackets. Vertically | |
align the top section of the door with the | ||
| ||
7/16” Socket | lower sections. Once aligned, position | |
the top bracket slide, out against the | ||
Driver | ||
horizontal track. | ||
| ||
7/16” Wrench | Maintaining the slide’s position, tighten | |
| ||
Step Ladder | the (1) 5/16” - 18 nut to secure the slide | |
| to the top bracket. Next lock the top | |
| slide into place on the top bracket using | |
| (1) 1/4” - 20 x 9/16” track bolt and (1) | |
| 1/4” - 20 hex nut through any two | |
| aligning holes. Repeat for other side. |
Top | Top |
section | section |
Correct | Incorrect |
TOP BRACKET
BASE
TOP BRACKET slide
Top
SECTION
(1) 1/4” - 20 hex NUT
INSTALLATION
(1)1/4”- 20 x 9/16” track bolt
(1)5/16”- 18 NUT
12 | Torsion End Bearing Brackets | Right hand end | Left hand | |
bearing bracket | ||||
end bearing | ||||
|
| |||
|
| bracket | ||
Tools Needed: | End bearing brackets are right and left |
| UPPER SLOTS | |
Power Drill |
| USED ON 15” | ||
hand. Break the end bearing brackets |
| |||
| RADIUS TRACK | |||
7/16” Socket | apart. |
| ||
|
| |||
Starting on the left hand side and using |
|
| ||
Driver |
| Wallangle | ||
the upper slots in the end bearing |
| |||
9/16” Socket |
| |||
Break |
| |||
bracket, position above the wallangle |
| |||
Ratchet Wrench | the end |
| ||
and secure the end bearing bracket to |
| |||
bearing |
| |||
9/16” Wrench | the horizontal angle using (2) | Horizontal | ||
brackets | ||||
x 3/4” truss head bolts and (2) | ||||
Step Ladder | apart | angle | ||
nuts. |
|
| ||
|
| Left hand end | ||
|
|
| ||
| IMPORTANT: End bearing brackets |
| bearing bracket | |
|
|
| ||
| must be attached through the | (1) 5/16” x | (2) | |
| upper slots on 15” radius track. | |||
|
| lag screw | truss head bolts | |
| Once the bracket is secured to the | Wallangle |
| |
| horizontal angle, secure the top of the |
| ||
|
|
| ||
| end bearing bracket to the jamb using |
|
|
(1)5/16” x
NOTE: Right and left hand is always | (2) |
|
nuts |
| |
determined from inside the building |
| |
Horizontal |
| |
looking out. |
| |
angle |
| |
|
| |
Please Do Not Return This Product To The Store. Contact your local | 15 |
To find your