Wayne-Dalton WDHC-20 user manual Receive Controller Copy

Transferring Primary Controller Role with Network Information Only:

1.Place the two controller’s near each other.

2.On Teleport™, press the HOME mode key.

3.Press and hold SETUP until the HOME red LED blinks twice.

4.Enter 966 on the numeric keypad. The HOME red LED blinks twice.

5.Press CH-; the HOME red LED blinks rapidly.

6.Put the target (secondary) controller into receive mode. Refer to the target controller’s user manual for specific instructions.

The Teleport™ HOME key green LED blinks twice to indicate a successful operation.

NOTE: If the HOME red LED emits one long, steady blink, the operation was not successful; repeat the sequence.

7.Add nodes, groups, and scenes to the new secondary controller as needed.

RECEIVE CONTROLLER COPY

You can transfer the Z-Wave®network information from another Z-Wave®controller to Teleport™. This would then allow Teleport™ to become a new secondary controller or a primary controller if the existing primary controller is programmed to transfer the primary role.

Receiving Z-Wave®Network Information from another Controller:

1.Place the two controllers near each other.

2.On Teleport™, press the HOME mode key.

3.Press and hold SETUP until the HOME red LED blinks twice.

4.Enter 967 on the numeric keypad. The HOME red LED blinks twice.

5.Put the primary controller into copy send mode.

Refer to the primary controller’s user manual for specific instructions.

The Teleport™ HOME key green LED blinks twice to indicate a successful operation.

NOTE: If the HOME red LED emits one long, steady blink, the operation was not successful; repeat the sequence.

6.Add nodes, groups, and scenes to the Teleport™ remote as needed.

26