Wayne-Dalton WDHC-20 user manual Programming Device Mode Control

3.Align the keys in the cover with the keys in the case and press the cover back into place. The tab should click when the cover is locked.

4. Test the remote control by pressing any mode key (e.g. TV.) If the batteries are inserted correctly, the LED (red light) will blink once.

NOTE: When batteries need replacement, the mode LED blinks 5 times with each key press. Replace the batteries and the unit will be restored to its full functionality, complete with your favorite settings.

PROGRAMMING DEVICE MODE CONTROL

The Teleport™ Remote Control is pre-programmed to operate an RCA satellite receiver, TV, DVD player, and VCR. It can also control Z-Wave®certified devices, regardless of manufacturer. To control devices other than the default brands, perform the following steps; otherwise skip this section.

NOTES: For control of a Combo device (for example, a TV/VCR combo), skip this section and perform the instructions on “Setting Up a Combo Unit” on page 11. Also, refer to “Device Table” on page 8 to determine which devices can be programmed onto each device key.

1.Turn on a device and, if applicable, insert video media, (e.g., cassette or disk.)

NOTE: Please read Steps 2 - 4 completely before proceeding. Highlight or write down the codes and device you wish to program before proceeding to Step 3.

2. On the remote control, press a mode key once (i.e., TV, DVD/VCR, SAT or AMP); it will blink once. Then press and hold SET UP until the selected mode key blinks twice.

3.Use the “Manufacturer’s Codes” (starting on page 31) to locate the type of device and brand name, then enter the first five-digit code for your device. If performed correctly, the selected mode key will blink twice.

NOTE: If the selected mode LED emits one long, steady blink, the operation was not successful; repeat the sequence.

Continued next page...

9