Wayne-Dalton WDHC-20 user manual Setting Up Z-Wave Scenes

SETTING UP Z-WAVE®SCENES

A Z-Wave®SCENE is a one or more Z-Wave®nodes that can be pre-set to turn to a previously specified setting (ON, OFF, DIM brightness level, etc...). The Teleport™ remote control allows you to set up a maximum of 20 scenes, containing up to 64 nodes per scene.

Adding a Z-Wave®Node to a SCENE

1.On Teleport™ press and release HOME once.

2.Press and release ADD once.

3.Press and release SCENE once.

4.Press and release a scene number for the scene you wish to add the node to. For scenes 0 - 9 press and release the number for the scene (e.g. 2 for scene 2,) for scenes 10 -19, press SETUP then the second digit of the scene number (e.g. SETUP + 4 = scene 14.) The HOME red LED blinks rapidly.

5.Press the program button on the node.

6.The HOME green LED blinks twice, then the HOME red LED blinks rapidly. Adjust the brightness on the Z-Wave®node within 30 seconds. To configure the node to turn on/off to max/min levels, simply press OK without adjusting brightness.

7.Press OK to save the node in the scene.

NOTE: If the HOME red LED emits one long, steady blink, the operation was not successful; repeat the sequence. Be certain Teleport™ is within 3 ft. of the the node.

Removing a Node from a SCENE

1.On Teleport™ press HOME once.

2.Press and release REMOVE once.

3.Press and release SCENE once.

4.Press and release a scene number for the scene you wish to remove the node from. For scenes 0 - 9 press and release the number for the scene (e.g. 2 for scene 2,) for scenes 10 -19, press SETUP then the second digit of the scene number (e.g. SETUP + 4 = scene 14.) The HOME red LED blinks rapidly.

5.Press the program button on the node.

6.The HOME green LED blinks twice, then the HOME red LED blinks rapidly.

NOTE: If the HOME red LED emits one long, steady blink, the operation was not successful; repeat the sequence.

22