GAS INSTRUCTIONS
Check
A) | Regulator hose to bulkhead connection (1). |
|
|
|
B) | Main gas line to bulkhead connection (2). |
|
|
|
C) | Main gas line to manifold connections (3). |
| 4 | |
WARNING: If there is a leak at connections (1, 2, or 3), |
| |||
|
|
| ||
| retighten the fitting with a wrench and recheck for leaks with |
|
|
|
| soap and water solution. If a leak persists after retightening |
|
|
|
| the fitting, turn OFF the gas. DO NOT OPERATE THE GRILL. |
|
|
|
| Contact the Customer Service Representative in your area |
|
|
|
|
|
|
| |
| using the contact information on our web site. |
|
|
|
| Log onto www.weber.com®. |
|
|
|
D) | Regulator hose to cylinder connection (4). | 6 | 5 | |
E) Regulator hose to regulator connection (5). |
|
|
| |
F) | Valves to manifold connections (6). |
|
|
|
WARNING: If there is a leak at connections (4, 5, or 6), turn
OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site.
Log onto www.weber.com®.
When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.
Reinstall Control Panel
You will need: Phillips screwdriver.
A) Position top edge of control panel on tabs of frame. Push down into position. B) Reinstall igniter module.
C) Slide both shorter wind deflector tabs toward inside edge of control panel while you slide longer tab over outside edge. Seek previous illustrations for reference.
D) Line up screws with screw holes on both control panel bracket and frame. E) Tighten screws.
F) Place corresponding control knobs onto valve stems. ◆
1 | 2 | |
3 | ||
|
The grill illustrated may have slight differences than the model purchased.
REFILLING THE LIQUID PROPANE CYLINDER
We recommend that you refill the LP cylinder before it is completely empty.
Removal of the LP cylinder: | 3 | ||
A) | Close cylinder valve (turn clockwise) (1). |
| |
B) | Unscrew regulator coupling by turning counterclockwise, by hand only (2). |
| |
C) | Loosen cylinder lock wing nut and turn cylinder lock up out of the way (3). | 2 | |
D) | Lift cylinder off. | ||
| |||
To fill, take the LP cylinder to a gas propane dealer, or look up | 1 | ||
phone book for other sources of LP gas. |
| ||
WARNING: We recommend that your LP cylinder be filled at an authorized LP gas dealer, by a qualified attendant, who fills the cylinder by weight. IMPROPER FILLING IS DANGEROUS.
CAUTION: Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane. ◆
12
