Weider WESY97300 Locate the Press Cable, Two 5/16 Nylon Jam Nuts, Cable to pivot, Locknut

CABLE ASSEMBLY

23.Attach the High Cable (23) to a Small “U”- Bracket (67) with a 1/4” Nylon Locknut (2)

and a 1/4” Washer (10). Do not completely

tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing.

24. Locate the Press Cable (58).	Attach the
Press Cable to the Rear Upright (56) with a
5/16” x 3” Bolt (93), a 5/16” Washer (8), and
two 5/16” Nylon Jam Nuts (84).	The end of
the Cable must be between the two Nylon
Jam Nuts and there must be enough room
between the Nylon Jam Nuts for the end
of the Cable to pivot.

Wrap the Press Cable (58) around a 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the Squat Arm (79) with a 3/8” x

3 3/4” Bolt (71), a 3/8” Washer (9), and a 3/8”

Nylon	Locknut (21).	The Cable Trap must be
turned	to hold the Cable in place.

25. Attach the end of the Press Cable (58) to the Long “U”-Bracket (57) with a 1/4” Nylon Lock-

nut (2) and a 1/4” Washer (10). Do not com- pletely tighten the Nylon Locknut. It

should be threaded onto the end of the Cable so only a couple of threads are showing above the nut, as shown in the inset drawing.

13

23
		23
	23	67
	10
	2	10
	67	2
24
		21
	79	9
	58	93
66	15	8
		56
71	84
25
		58
		57
		10
	58
	10	2
	2
	57