ASSEMBLY
Before beginning assembly, carefully read the following information and instructions:
•Place all parts of the home gym system in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.
•The assembly is divided into four stages: 1) frame assembly, 2) press, squat, and butterfly arm assembly, 3) cable and pulley assembly, and
4)seat and backrest assembly. The hardware for each stage is packaged separately.
•Wait until you begin each assembly stage to open that parts bag.
•For help identifying the small parts used in assembly, use the PART IDENTIFICATION
CHART located in the center of this manual. Note: Some small parts may have been pre- attached for shipping. If a part is not in the parts bag, check to see if it has been
•As you assemble the home gym system, be sure that all parts are oriented as shown in the drawings.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) phillips screwdriver
• One (1) rubber mallet
•Lubricant, such as grease or petroleum jelly, and soapy water will also be needed.
Assembly will be more convenient if you have the following tools: A socket set, a set of
FRAME ASSEMBLY
1. Before beginning assembly, be sure that | 1 |
|
|
you have read and understand the infor- |
|
| |
|
|
| |
mation in the box above. | 27 | 51 |
|
Press a 2” Square Inner Cap (27) into the |
| 11 | 78 |
|
|
| |
end of the Rear Base (51). Press a 2” Square |
|
|
|
Cover Cap (78) onto each end of the |
|
|
|
Stabilizer (5). |
|
|
|
Insert two 5/16” x 2 1/2” Carriage Bolts (1) | 11 | 1 | 5 |
|
| ||
up through the Rear Base (51). Insert two |
|
|
|
5/16” x 2 3/4” Bolts (11) through the Rear | 78 |
|
|
Base and Stabilizer (5) as shown. |
|
| |
|
|
| |
2. Press a 2” Square Inner Cap (27) into the | 2 |
|
|
end of the Front Base (4). |
|
| |
|
|
| |
Insert two 5/16” x 2 1/2” Carriage Bolts (1) | 51 |
|
|
| 3 |
| |
up through the Front Base (4). Slide the | 5 |
| |
Front Base onto the two 5/16” x 2 3/4” Bolts |
|
| |
|
|
| |
(11) in the Rear Base (51) and Stabilizer (5). |
|
| 4 |
Fully tighten two 5/16” Nylon Locknuts (3) |
| 11 | |
onto the Carriage Bolts. |
|
| |
|
|
| |
|
| 1 |
|
|
|
| 27 |
5
