ARM ASSEMBLY
10.Press a 1 3/4” Square Inner Cap (44) into the top of a Press Arm (46). Press a 1” Round
Inner Cap (49) into the side of the Press Arm. Attach the Press Arm to one side of the
Press Frame (17) with two 5/16” x 2 1/2” Bolts (22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same manner.
11.Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded bracket
on each Arm. Arm identification is very important for step 12.
Attach a
2 .1/2” Bolt (7) and a 3/8” Nylon Locknut (21).
Attach a
2 .1/2” Bolt (7) and a 3/8” Nylon Locknut (21).
12.Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step 11 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55).
Tap two 1” Retainers (69) and a 1” Round
Cover Cap (70) onto the right axle. Be sure that the teeth on the Retainers bend
toward the Cover Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with
soapy water. Slide a 10” Pad (45) onto the lower end of each Arm.
9
10 |
| 44 | 49 |
|
|
| |
44 |
|
|
|
|
|
| 46 |
49 |
|
|
|
46 | 22 |
|
|
|
|
| |
|
| 17 | 3 |
|
|
| |
11 | 7 | 50 |
|
|
| ||
50 | 6 |
|
|
|
| 47 | |
Welded |
|
| |
|
|
| |
Brackets |
|
|
|
|
| 21 |
|
48 |
|
|
|
12 |
|
|
|
|
| Bracket | 47 |
|
|
| |
55 |
| Lubricate |
|
| Axle |
| |
|
| 69 | 45 |
|
| 70 |
|
48 |
|
|
|
44 |
|
|
|
|
| Axle |
|
45 |
|
| 69 |
|
|
| 70 |
