PROBLEM
Control knob(s) will not turn
Cooking results are not what you expected
The display shows “PF”
The display shows “Fl” Dr “F3”
POSSIBLE CAUSE
You are not pushing in before turning.
The range clock does not show the correct time of day.
The Lock Lever is not in the Clean
A delayed start time has been programmed.
The range is not level.
The oven temperature seems too low or too high.
The oven was not preheated as the recipe calls for.
The recipe has never been tested or is not from a reliable source.
The pans are not the type or size recommended in the recipe.
There is not proper air circulation around pan when baking.
Flame size does not fit the cooking utensil being used.
When broiling, you have not completely closed the oven door.
There has been a power failure.
SOLUTION
Push control knob(s) in before turning to a setting.
Reset clock to show the correct time of day. (See page 11.)
Move Lock Lever all the way to the right.
Wait for the start time to be reached.
Level range. (See Installation Instruc- tions.)
Adjusting the oven temperature control. (See “Adjusting the oven temperature control” on page 14.)
Preheat oven if called for in recipe.
Use only tested recipes from a reliable source.
Refer to a reliable cookbook for recom- mended pan type and size.
Allow 1l/2 to 2 inches
Adjust flame size to fit cooking utensil.
Completely close oven door.
Reset the clock. (See page 11.)
Call for service. (See Step 3 on page 39.)
38
