FAQs |
|
|
|
|
| |
|
|
|
| |||
3. My furnace (air condi- | The |
|
| |||
tioning) cycles too fast | Anticipation) that allows you to increase or decrease the cycle times in heating and cooling. |
|
| |||
(slow). Is there an adjust- | This is useful if you think your cycle times are too long or too short. The higher the number |
|
| |||
ment? | you select, the longer the cycle. The lower the number you select, the shorter the cycle. The |
|
| |||
|
|
| ||||
| adjustment for | HEATING is from 1 to 40. The factory Preset is 05, the range of |
| adjustment | ||
| for COOLING is from 9 to 40. The factory Preset is 24. The cooling will not go below 9 | |||||
| because compressors require a longer cycle. See page 6 of your Installation Instructions. | |||||
|
|
|
| |||
4. Why does the blower fan | Normally the blower will turn off within a few minutes after the call for heat or cool. The |
| FAN ON, | |||
keep running after the | blower running after the system shuts off may indicate (1) the thermostat is set to |
| ||||
system has shut off? | (2) the fan has been programmed to run at that time period or (3) something has damaged the |
|
| |||
| thermostat or equipment. If the thermostat display indicates | FAN ON, press the fan button | ||||
| once to set it to | FAN AUTO, meaning the fan will cycle only with the equipment. If the |
|
| ||
| display indicates | PRG FAN (Program Fan), sometime during programming, the |
| FAN | ||
| button was pushed. To remove | PRG FAN (Program Fan), check all of the programmed |
| |||
| times and temperatures. When you encounter | PRG FAN, press the | FAN | button to | ||
| remove it from that time period in the program. As a final test, set the thermostat to |
| OFF. | |||
| Verify that FAN ON or | FAN AUTO is not displayed. If the fan continues to run, you may |
| |||
| want to contact your heating and cooling service person for assistance. |
|
|
| ||
|
|
| 27 |
|
|
|
|
|
|
|
|
|