FEATURES
Pushbutton Backlight
The large numbers and letters on your LCD screen make it easy to see. In low light conditions, press the button on top of the thermostat and the display will light up for three seconds. For ten minutes after pressing the light button, pressing any other button will light the display for ten seconds.
Factory Preprogramming
This thermostat has been programmed at the factory. The chart in the programming examples section lists these factory settings. If the times and temperatures are the same as your schedule, you may simply run the factory installed program by pressing
PROGRAM RUN .
Temporary Program Override
Any time your program is running and |
|
| |||
| you would like to override it for a |
|
| |||
specific amount of time, press |
|
|
| ||
or | until the temperature you |
|
| ||
| want is displayed. The display will |
|
| |||
indicate | HOLD, and the number of |
| |||
hours remaining in the hold period is |
|
| |||
| indicated with the word | HRS | . To | |||
| adjust the length of time for the |
|
| |||
| override, press | TIME | FWD | or | TIME | |
BACK . HOLD TILL will be displayed | |||||
as well as the HOLD period expiration |
|
| |||
| time. Press |
| TIME | FWD or | TIME |
|
BACK buttons until you reach the time |
|
| |||
| you would like it to resume the |
|
| |||
program. The |
| TIME | FWD | or | TIME |
BACK buttons adjust the time in 15 minute increments. This pro-
grammed hold time has a 19 hour
maximum and
20). If you need to, you can adjust the temperature up or down.
Indefinite Program Hold.
If you want to operate the thermostat to keep a set temperature without a
program running, press PROGRAM
HOLD . The temperature Up or Down buttons can be used to raise or lower the temperature. The thermostat will hold the set temperature until you return to the program by pressing
PROGRAM RUN .
18
