Without Quick Hitch Attachment:
1.Back tractor lower
2.Place
3.Push tractor’s
4.Repeat steps 5 and 6 for other side.
5.Lower the tractor’s top link arm and secure in top hole of upper mast assembly using spacer, hex bolt, and lock nut. (See illustration and parts list, page
Pull-Type Model:
1.Use the ratchet (see Figure 7) on top of the hitch to set the hitch height.
2.Check and set the drawbar dimension.
3.Back the tractor up to the hitch.
4.Use a hardened drawbar pin that provides for a mechanical retainer, such as a Klik pin.
5.Attach safety chain from hammer strap around the drawbar or cage to prevent unexpected separation. Provide sufficient slack for turning.
6.Use the ratchet to transfer the unit’s weight to the drawbar.
7.Make sure the drawbar is pinned in its center position.
Figure 7. Attaching to Pull-Type Model
Figure 8. Drawbar & Safety Chain
Attach PTO Driveline
1.Make sure the driveline telescopes easily and shields rotate freely.
NOTICE
■The drawbar may need repositioning to provide clearance for the driveline.
2.Attach the driveline to the tractor by retracting the locking collar. Slide the yoke over the shaft and push on the yoke until the lock collar clicks into position. Make sure the yoke is locked into position. See Figure 9.
Figure 9. Locking Collar
Attach Hydraulics (Center Cutter Option)
1.Use a clean cloth to clean hose ends and area around the couplers on the tractor.
2.Insert the hose male ends into the tractor couplers. Make sure hoses lock in place.
3.Route hoses along or over the hitch and secure in position with clips, tape, or plastic ties. Provide enough slack for turning and lifting.
18 Operation | MAN0506 (Rev. 9/5/2008) |
|
|
