Woods Equipment S25CD, S22CD, S20CD ALL Units, PULL-TYPE Hitch Installation, Pull-type units only

7.Attach front top link spacer, bolts, and lock nuts to front of upper mast assembly.

NOTE:

For Quick Hitch Cat II, use spacer in front lower hole of upper mast assembly.

For Quick Hitch Cat III, use spacer in front upper hole of upper mast assembly.

Without Quick Hitch, use spacer through top link pivot in front upper hole of upper mast assembly.

8.Assemble lower 3-point hitch pin assembly, spacers, and klik pin to lower mast (both sides).

NOTE: For Quick Hitch Cat II & III, place 1-3/4 OD spacer on the inside and 1-7/16 OD spacer on the outside.

1

7082Z

Figure 42. Floating Upper Mast Installed

ALL UNITS

1.Install PTO driveline by sliding the yoke with the slip clutch over the input shaft (Figure 43).

2.Tighten interlocking clamp bolts to their specified torque.

3.Install front parking stands (Figure 44), using L-pin and hair pin cotter.

Figure 44. Front Stands Installed

PULL-TYPE HITCH INSTALLATION

(Pull-type units only)

1.Mount hitch to 3-point lower mounts, using pins and Klik pins.

2.Install ratchet. Be sure to install retaining pins.

3.Attach clevis or pin to hitch tongue (See page 48 for parts breakdown.)

4.Attach tow chain to hitch.

Figure 45. Pull-Type Hitch Installed

Figure 43. Gearbox Input Shaft

MAN0506 (Rev. 9/5/2008) Assembly 39