Install Motor Housing
1.Slide motor assembly between shredder center channel and secure to the left side using two 1/2 NC x
(30).
2.Install 1/2 NC x 1 cap screw (31) and flat washer
(32)to the right rear hole of the motor housing and secure with flange lock nuts (30).
3.Install 1/2 NC x
4.Raise motor housing to the bottom of the mounting slots and torque hardware to 85
31
30
29
DP1
Figure 54. Motor Assembly Installed
Assembly Hoses
1.Attach male quick coupler (17) and adapter (16) to the end of hose (15). Attach tee (12) to the opposite end of hose.
2.Attach male quick coupler (17) and adapter (16) to the end of second hose (15). Attach check valve (14), nipple (13) and tee (12) to the opposite end of hose.
NOTE: Make sure flow indicator arrow on the side of the check valve (14) is pointing in the correct direction. See Figure 55
3.Install check valve (14) and two nipples (13) between the two tees (12).
NOTE: Make sure flow indicator arrow on the side of the check valve (14) is pointing in the correct direction.
4.Place hose assembly around center plate of shredder and drape quick couplers over the front of the shredder. See Figure 55 and Figure 56.
5.Make sure hose with check valve is on the right side of the center plate.
Figure 55. Hose Assembly
6.Route hose (11) from the IN side of the motor between shredder and rockshaft and attach it to tee (12) on the left side of the center plate.
7.Route hose (11) from the OUT side of the motor between shredder and rockshaft and attach it to tee (12) on the right side of the center plate.
| RETURN |
|
PRESSURE |
| Center Plate |
|
| |
|
| Check |
|
| Valve |
11 |
|
|
|
| ht |
|
| Rig |
ft |
|
|
Le |
|
|
| IN | 11 |
| OUT | |
|
| |
|
| DP2 |
Figure 56. Hose Routing
MAN0506 (Rev. 9/5/2008) | Assembly 43 |
|
|
