Woods Equipment S15CD manual Center CUT KIT Installation, Block Shredded, Assemble Motor and Blade

CENTER CUT KIT INSTALLATION

Block Shredded

„Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked and secured. Never place any part of the body under- neath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak down, hydraulic system failures, mechanical failures, or movement of control levers can cause equipment to drop or rotate unexpect- edly and cause severe injury or death. Follow Oper- ator's Manual instructions for working underneath and blocking requirements or have work done by a qualified dealer.

To minimize the potential hazards of working under- neath the cutter, follow these procedures.

1.Jackstands with a load rating of 2000 lbs or more are the only approved blocking device for this cutter. Install a minimum of four jackstands under the shredder before working underneath unit.

Do not position jackstands under wheels, axles, or wheel supports. Components can rotate and cause shredder to fall.

2.Consider the overall stability of the blocked unit. Just placing jackstands underneath will not ensure your safety.

The working surface must be level and solid to support the weight on the jackstands. Make sure jackstands are stable, both top and bottom. Make sure shredder is approximately level.

3.With full shredder weight lowered onto jackstands, test blocking stability before working underneath.

4.If shredder is attached to tractor when blocking, set the brakes, remove key, and block shredder before working underneath.

5.Securely block rear tractor wheels, in front and behind. Tighten tractor lower 3-point arm anti-sway mechanism to prevent side-to-side movement.

Assemble Motor and Blade

1.Install elbow (8), adapter (9), elbow (10) and hose

(11)to the IN or PRESSURE side of the hydraulic motor.

2.Install adapter (23) and hose (11) to the OUT or RETURN side of the motor.

3.Place motor (4) inside motor housing (2) and secure using six 9/16 NC x 1-1/2 cap screws (7) lock nuts (6).

Make sure OUT or RETRUN side of motor is on the open side of the motor housing. Torque hardware to 171 lbs-ft.

4.Slide blade hub (1) over motor shaft, install 1/4" key and secure using one 5/16 NF x 1-1/2 cap screw (20), flat washers (33) and lock washer (34) in the bottom of the shaft. Torque to 19 lbs-ft.

5.Clamp hub to shaft using two 3/8 NC x 1-3/4 cap screws (18) and lock nuts (22). Torque to 35 lbs-ft.

6.Secure blade (3) to blade hub using two 3/8 NC x 1-1/4 cap screws (19) and flange lock nuts (22). Torque to 35 lbs-ft.

Figure 53. Motor Assembly

42 Assembly MAN0506 (Rev. 9/5/2008)