Interconnection Standards Compliance | Xantrex Technology PV-225208

SECTION 1

PRODUCT DESCRIPTION

Power Control Unit (PCU)

The PCU is a Digital Signal Processor (DSP) based control board that performs numerous control and diagnostic functions associated with PV-225208 operation. Its most significant tasks are control of PV-225208 electromechanical components and power electronics converters, signal conditioning for high voltage signal inputs and communication with the operator interface panel and system sensors. The PCU also contains the necessary DC power supplies to support its operation.

INTERCONNECTION STANDARDS COMPLIANCE

The PV-225208 has been tested and listed by Underwriters Laboratories to be in compliance with UL1741 Static Inverters And Charge Controllers For Use In Photovoltaic Power Systems, as well as IEEE- 929-2000 Recommended Practice For Utility Interface Of Photovoltaic (PV) Systems.

IEEE-929-2000 provides guidance regarding equipment and functions necessary to ensure compatible operation of photovoltaic systems which are connected in parallel with the electric utility. UL1741 is the standard applied by Underwriters Laboratory to the PV-225208 to verify it meets the recommendations of IEEE-929-2000. Refer to both documents for details of these recommendations and test procedures.

F-F	E-E
	Figure 1-2

DOCUMENT: 151811	PV-225208 Photovoltaic Inverter	1-3
	Operation and Maintenance Manual

Copyright 2003, Xantrex Technology Inc.

Image 5

Xantrex Technology PV-225208 important safety instructions Interconnection Standards Compliance, Power Control Unit PCU

Contents

Manual Table of Contents Section Product Description Introduction Operation and Maintenance ManualMajor Components Main Enclosure Control Components Section Product Description Interconnection Standards Compliance Power Control Unit PCU Equipment Symbol Section Product Description Specifications Main Enclosure Door Interlock Switch Section Safety Safety FeaturesFault Reporting PV Ground Fault Detection Isolation Procedure Section SafetyOver/Under Voltage and Frequency Anti Island Protection Utility Side Isolation Transformer Requirements Torque and Wire Gauge Specifications Installation Section Installation and Initial TURN-ONInstallation Instructions Cable Entry Area Array Grounding Ground Fault Detection Interconnection Wiring PV Array Frame Ground DC Interface PV-225208 Inverter Wiring Diagram Chassis Gnd TransformerInterface Circuit Breaker Initial Power Visual Inspection, PV Array WiringVisual Inspection, Isolation Transformer WYE/WYE Visual Inspection, PV-225208 System Verification Power Tracker Fine Tuning Operating States Section Operation Description of System OperationOverview Fixed Unity Power Factor Operation Operation FeaturesUtility Voltage/Frequency Fault Automatic Reset Section Operation Operator Interface Peak Power TrackingCurrent Imbalance Detection DC Overvoltage Detection Section Operation Setting the Date and Time Commanding Goal State ChangesManual State Transitions Changing Write Parameter Values Automatic State Transitions Sleeping → Power Tracking → Sleeping Any State → Fault AUTO-RESTART FeatureTURN-ON Procedure Alarm and Fault Conditions Section Troubleshooting General Programming Mode S Section TroubleshootingPV Overvoltage S Bad Memory S PV Auxiliary Switch Open H Door Interlock Switch Open HAC Voltage Too Low S AC Voltage Too High S YY27/YY28 Line Over-Current Fault S XX25/XX26 Line Gate Drive Fault S DC Bus Voltage High H PV Over-Current Fault S Section Preventative Maintenance Periodic Maintenance Section Preventative Maintenance Read-Only Parameters Section Appendix Faults CodesREAD/WRITE Parameter Menu Inverter States Section Appendix ADC Drawings List Warranty and Certification Xantrex PV Series Limited Warranty and Registration Page Page Page Page Page Fab, Enclosure, Upper, 2 Bay, PV225208 Page Fab, Enclosure, DC Interface, PV225208 Page TB5 Source Control Specification