2.0 INSTALLATION
Deltec™ Shunt
WARNING: BEFORE WIRING THE SHUNT TO THE BATTERIES, SWITCH THE DC DISCONNECT TO OFF AND/OR REMOVE THE DC FUSE.
Mounting/Wiring the Shunt
The shunt connects between the inverter and batteries in the negative
•Mount the shunt on or near the battery enclosure close to the negative
(–)battery terminal. Use appropriate screws to secure the shunt to the battery enclosure.
•Disconnect the NEGATIVE cable (that connects between the inverter and battery) from the battery’s negative
•Connect the free end of the negative cable to the shunt’s terminal labeled “INVERTER.” Ensure all connections are tight.
•Connect a short length of cable (same gauge) between the battery’s
•Connect the cables and hardware to the shunt as shown in Figure
NOTE: The cable connection must be flat against the shunt block with nothing between it for a good connection.
To Battery’s
Negative Terminal
Shunt Hex Bolt (9/16 inch head) Split Lock Washer
Large Washer Cable Lug Shunt
Figure
Shunt Connections
© 2001 Xantrex Technology Inc. | 9 |
P/N |