Xantrex Technology TM500A Setting Parameters continued CHARGED Indicator Setup continued, 14.4

3.0 CONFIGURATION

Setting Parameters (continued)

CHARGED Indicator Setup (continued)

14.4

1A

4A 2A 3A

Set Voltage Level

Voltage LED

Illuminates to Indicate the Voltage Function is Selected

Figure 3-5

Setting the CHARGED Indicator Voltage Level

The fully-charged voltage parameters are now set. To allow the voltage only setting to trigger the fully-charged LED, the amperage setting must be switched OFF.

Step B Switching OFF the Amperage Detection

1B. Press the SELECT button until the Amperage LED ( A ) is illuminated.

2B. Press the SELECT and RESET buttons simulataniously until the LED display flashes.

3B. Press the RESET button until the display indicates OFF.

4B. Press SELECT button to accept.

The TM500A is now setup to trigger the CHARGED indicator LED () when the voltage level equals or exceeds the value programmed in Step A. When this voltage parameter is met, the CHARGED indicator LED flashes approximately every four seconds.

NOTE: The CHARGED indicator remains ON (solid) even when the batteries are discharging, until reset.

OFF

1B

4B

Set Amps to

OFF

Amperage LED

Illuminates to Indicate

the Amperage

Function is Selected

2B 3B

Figure 3-6

Turn Amps OFF for VOLTAGE ONLY Detection

18 © 2001 Xantrex Technology Inc.

P/N 973-0012-01-02 Rev.A05/01