2.0 INSTALLATION
Connecting the Shunt Board
•Remove the fuse from the
•Connect the ring terminal from the fuse holder to the battery’s positive terminal.
•Connect the shunt communications cable into the RJ11 jack on the shunt board. This cable can be extended up to 100 feet (30 meters).
•Replace the fuse in the fuse holder. Replace the fuse holder cap by pushing and rotating it clockwise.
To battery’s |
| To J1 |
| connector on | |
positive |
| back of |
terminal | meter |
Figure
In-line Fuse
DC FUSE
DISCONNECT
+ | - |
+
BATTERY
SHUNT
-
INVERTER
INVERTER
SHUNT
SHUNT WIRE
RC4/RC8
REMOTE
JACK
GROUND WIRE |
|
(IF RUN IS OVER |
|
100 FEET) |
|
TRACE |
|
METER |
|
(Back View) | J1 |
J2 |
|
REMOTE JACK |
|
INVERTER ON/OFF
REMOTE CABLE
TC10, TC25, TC50, TC100
(NOT SUPPLIED)
SHUNT JACK
Figure
Circuit Diagram
© 2001 Xantrex Technology Inc. | 11 |
P/N |