Xantrex Technology TM500A manual Mounting Circuit Board to an Existing Shunt, Installation

2.0 INSTALLATION

Mounting Circuit Board to an Existing Shunt

Model TM500A - NS is supplied without a shunt and is intended to be wired to an existing shunt. The kit includes two brass 8-32 x 5/8 inch machine screws, two lock-washers and two metal standoffs.

NOTE: The shunt must be of the proper type (50 mV/500 amps) and have the necessary threaded screw holes to accommodate the shunt board.

•Remove the existing two machine screws (if installed) and hardware from the side of the shunt.

•Install the shunt circuit board and supplied hardware exactly as shown in Figure 2-8.

NOTE: Use only the hardware supplied in the kit.

Brass Screw	Spade Lug
	(for extended length installations)

Brass Lock

Washer

Metal Standoff

Figure 2-8

Shunt Circuit Board and Hardware

10	© 2001 Xantrex Technology Inc.
	P/N 973-0012-01-02 Rev.A05/01