Xerox 8850 manual Changing the roll media size and type

MEDIA

Changing the roll media size and type

Whenever you open a media drawer, the message display prompts you to change the type or width of the media. If you have not changed the type or width of the roll media in the drawer, press the Exit key. If you have changed the type or width, you must enter the new information.

To change the roll media size and type:

1.Press the Media key. The message display indicates the width and type of roll media last specified for drawer 1.

NOTE: The Media key is active from either on-line or off-line mode.

2.Press the Previous or Next key to scroll through the media source selections. The selections are ROLL1, ROLL2, ROLL3, and BYPASS SHELF (cut sheet feed-in shelf).

3.When you scroll to the media source you want to change, press the Enter key. The message display instructs you to select the media width. It indicates the current media width.

NOTE: Media width does not apply to the BYPASS SHELF selection. If you have selected BYPASS SHELF as the media source, the message display instructs you to select the media type. Proceed to step 6.

4.Press the Previous or Next key to scroll through the media width selections. The width selections are:

11.0 INCH	297 MM.
12.0 INCH	353 MM.
17.0 INCH	420 MM.
18.0 INCH	500 MM.
22.0 INCH	594 MM.
24.0 INCH	620 MM.
30.0 INCH	707 MM.
34.0 INCH	750 MM.
36.0 INCH	841 MM.
	860 MM.
	880 MM.
	900 MM.

5.When you scroll to the desired media width, press the Enter key. The message display instructs you to select the media type. It indicates the current media type.

14 XES SYNERGIX 8850 PRINTER OPERATOR MANUAL