IMPORTANT INFORMATION/ CHECKING OF CONNECTION

GEN INFO

EC136000

CIRCLIPS

1.All circlips should be inspected carefully before reassembly. Always replace pis- ton pin clips after one use. Replace dis- torted circlips. When installing a circlip 1, make sure that the sharp-edged cor- ner 2 is positioned opposite to the thrust

3it receives. See the sectional view.

4 Shaft

CHECKING OF CONNECTION

Dealing with stains, rust, moisture, etc. on the connector.

1.Disconnect:

●Connector

2.Dry each terminal with an air bower.

3.Connect and disconnect the connector two or three times.

4.Pull the lead to check that it will not come off.

5.If the terminal comes off, bend up the pin 1 and reinsert the terminal into the con- nector.

6.Connect:

●Connector

NOTE:

The two connectors “click” together.

7. Check for continuity with a tester.

NOTE:

●If there in no continuity, clean the terminals.

●Be sure to perform the steps 1 to 7 listed above when checking the wireharness.

●For a field remedy, use a contact revitalizer available on the market.

●Use the tester on the connector as shown.

1 - 5