INSP

TIRE PRESSURE CHECK ADJ

4.To stiffen the spring preload, install the circlip 1 into the groove a. To soften the spring preload, install the circlip into the groove b.

NOTE:

Do not spread the circlip too much.

Standard installation position:Groove b

5.Install:

● Spring guide 1

NOTE:

While compressing the spring, install the spring guide.

6.Install:

●Rear shock absorber

Refer to “SWINGARM” section in the CHAPTER 5.

EC36Q000

TIRE PRESSURE CHECK

1.Measure:

●Tire pressure

Out of specification → Adjust.

Standard tire pressure:100 kPa (1.00 kgf/cm2, 14.5 psi)

NOTE:

●Check the tire while it is cold.

●Loose bead stoppers allow the tire to slip off its position on the rim when the tire pressure is low.

●A tilted tire valve stem indicates that the tire slips off its position on the rim.

●If the tire valve stem is found tilted, the tire is considered to be slipping off its position. Cor- rect the tire position.

3 - 14