Maintenance and care

cluded in the tool kit. Have the spark plug adjusted to the correct torque with a torque wrench as soon as possible.

(4)Install the spark plug cap, and then install the spark plug cap bolts and tighten them to the specified torque.

NOTE:

Wipe off any water on the spark plug or in- side the spark plug cap before installing the cap. Push the spark plug cap down until it is securely installed.

If the spark plug cap nearest the stern was removed, secure the wiring harness by in- stalling the plastic tie after installing the cap.

Spark plug cap bolt tightening torque: 7.6 Nm (5.6 ft-lb) (0.77 kgf-m)

EWJ00350

WARNING

Be careful not to damage the insulator when removing or installing a spark plug. A damaged insulator could allow sparks to escape, which could result in a fire or ex- plosion.

(5) Install the engine cover and engine cover screws, and then install the seats.

EJU36970

Lubrication points

To keep moving parts sliding or rotating smoothly, coat them with water-resistant grease.

Recommended water-resistant grease: Yamaha Marine Grease/Yamaha Grease A

Throttle cable (handlebar end)

Loosen the adjuster and disconnect the outer cable from the bracket. Spray a rust inhibitor into the outer cable. Connect the outer cable, and then adjust the throttle ca-

ble free play. (See page 95 for adjustment procedures.)

1 Adjuster

Steering cable (handlebar end)

Steering cable (jet thrust nozzle end)

QSTS rod (jet thrust nozzle end)

98