Operation
the watercraft was capsized. Normally, the water separator is empty.
the water is discharged from the electric bilge pilot outlet at the stern.
1
2
1
1Water separator
2Drain screw
If water remains in the water separator, drain it by removing the drain screw. Place a drain pan under the water separator to catch the draining water or use a dry cloth to soak up any water that could spill into the watercraft. If any water spills into the watercraft, be sure to wipe it up with a dry cloth. Also, be sure to install the drain screw after draining the water separator.
EJU32450
Bilge
Check the bilge for moisture and fuel residue. This watercraft is equipped with a conventional jet vacuum bilge draining system and an electric bilge draining system. The electric bilge draining system is operated when the engine is running. When excess water reaches the water inlet of the electric bilge pump,
1Electric bilge pilot outlet
A small quantity of water will remain in the bilge and should be drained manually. To drain any residual water, beach the watercraft and perform the following procedure.
ECJ00350
CAUTION:
If starting the engine after the watercraft has capsized, do not operate the engine at full throttle when water is being discharged from the electric bilge pilot outlet at the stern. Excessive water in the bilge can splash into the engine, which can result in severe damage.
To drain water from the bilge:
(1)Remove the stern drain plugs.
(2)Raise the bow of the watercraft until the water drains.
(3)After the water has drained, wipe the bilge with dry rags to make sure that it is thoroughly dry.
(4)Install the stern drain plugs.
ECJ00360
CAUTION:
●Before installing the stern drain plugs, clean the drain plug threads to remove any foreign materials, such as dirt or sand. Otherwise, the stern drain plugs
65