Yamaha HTR-5940 Sound suddenly, Goes off, Sound is heard from, Speaker on one, Side only

TROUBLESHOOTING

Problem	Cause	Remedy	See
			page
The sound suddenly	The protection circuitry has been activated	Check that the speaker impedance setting is correct.	25
goes off.	because of a short circuit, etc.
		Check that the speaker wires are not touching each	—
		other and then turn this unit back on.
	The sleep timer has turned off this unit.	Turn on this unit, and play the source again.	—
	The sound is muted.	Press MUTE or VOLUME +/– on the remote control	32
		to resume audio output.
Sound is heard from	Incorrect cable connections.	Connect the cables properly. If the problem persists,	18-24
the speaker on one		the cables may be defective.
side only.
	Incorrect settings in “SPEAKER	Adjust the “SPEAKER LEVEL” settings.	79
	LEVEL”.
Only the center	When playing a monaural source with a
speaker outputs	CINEMA DSP program, the source signal
substantial sound.	is directed to the center channel, and the
	front and surround speakers output effect
	sounds.
No sound is heard	“CENTER” in “SET MENU” is set to	Set “CENTER” to “SML” or “LRG”.	78
from the center	“NONE”.
speaker.
	One of the HiFi DSP programs (except for	Try another sound field program.	62
	6ch Stereo) has been selected.
No sound is heard	“SUR. LR” in “SET MENU” is set to	Set “SUR. LR” to “SML” or “LRG”.	78
from the surround	“NONE”.
speakers.
	This unit is in the “STRAIGHT” mode	Press STRAIGHT (EFFECT) on the front panel so	37
	and a monaural source is being played	that “STRAIGHT” disappears from the front panel
	back.	display.
No sound is heard	“SUR. LR” in “SET MENU” is set to	Set “SUR. LR” and “SUR. B” to “SML” or “LRG”.	78
from the surround	“NONE” and “SUR. B” is automatically
back speaker.	set to “NONE”.
	“SUR. B” in “SET MENU” is set to	Set “SUR. B” to “SML” or “LRG”.	78
	“NONE”.
No sound is heard	“BASS OUT” in “SET MENU” is set to	Set “BASS OUT” to “SWFR” or “BOTH”.	79
from the subwoofer.	“FRNT” when a Dolby Digital or DTS
	signal is being played.
	“BASS OUT” in “SET MENU” is set to	Set “BASS OUT” to “BOTH”.	79
	“SWFR” or “FRNT” when a 2-channel
	source is being played.

The source does not contain low- frequency bass signals.

INFORMATION ADDITIONAL

93