Yamaha LS9-16, LS9-32 3, 4, 5, 6, 7, 8

144

Using the Fade function

LS9-16/32 Owner’s Manual

2Make sure that the cursor is located some-

where other than the constant display area,

and use the dial or the [DEC]/[INC] keys to

select the scene for which you want to

make Fade function settings.

3Move the cursor to the SET popup button,

and press the [ENTER] key to access the

FADE TIME popup window.

In this popup window you can select the channels to

which Fade will be applied, and adjust the fade time.

1Channel display ﬁeld

The channels to which Fade is applied are highlighted.

BFADE TIME knob

This knob sets the fade time. Move the cursor to this

knob and use the dial or the [DEC]/[INC] keys to

adjust the setting.

CSET ALL button

If you press this button, the Fade effect will be enabled

for all faders/encoders of that scene.

DCLEAR ALL button

If you press this button, the Fade effect will be dis-

abled for all faders/encoders of that scene.

4Press the [SEL] keys of the desired chan-

nels to select the channels to which the

Fade effect will be applied (multiple selec-

tions are allowed).

The [SEL] keys of the selected channels will light, and

those channels will be highlighted in the channel dis-

play ﬁeld of the popup window. You can cancel a

selection by pressing a lit [SEL] key once again to

make it go dark.

5Move the cursor to the FADE TIME knob,

and use the dial or the [DEC]/[INC] keys to

adjust the fade time.

The range is 0.0 sec–60.0 sec.

When you’ve ﬁnished making settings, move the cur-

sor to the OK button and press the [ENTER] key to

close the FADE TIME popup window.

6To turn on the Fade function, move the cur-

sor to the FADING button and press the

[ENTER] key.

The Fade on/off setting is made individually for each

scene. Save the scene if necessary.

7Make Fade function settings for other

scenes as described in steps 2–6.

8Recall a scene for which the Fade function

is turned on.

The faders will begin to move immediately after

Recall occurs, and will reach the values of the recalled

scene over the course of the speciﬁed fade time.

123

• The fade time you specify here is used for all channels

selected in step 4.

HINT

• Scenes for which Fade settings are made are shown by a

“FADING” indication in the STATUS ﬁeld of the SCENE LIST

screen.

HINT

• The Fade function settings can be applied individually even if

faders are linked by Channel Link.

NOTE

• If you stop a moving fader while you hold down the corre-

sponding [SEL] key, the fade effect will stop at that point.

• If you recall the same scene while faders are moving, all

channel faders will move immediately to their target positions.

HINT