46
Setup required when starting up
LS9-16/32 Owner’s Manual
“Word clock” is the clock data that provides the timing
basis for audio signals to be processed digitally.
If a digital I/O card installed in a slot is digitally con-
nected to an external device such as a DAW system, CD
player, or HDR (hard disk recorder), and you want digital
audio signals to be transmitted or received between the
LS9 and the external device, you must synchronize the
word clock of the respective devices.
In order for this to occur, one device must be the word
clock master (transmitting device) and the other device
must be the slave (receiving device), and the slave device
must synchronize to the master device.
If you want to set the LS9 as the word clock slave so that it
will synchronize to the word clock supplied from an exter-
nal device, you can either use the clock data included in
the digital audio signal received from a digital I/O card, or
provide dedicated word clock to the WORD CLOCK IN
jack located on the rear panel.
In either case, you must use the following procedure to
specify the word clock source that the LS9 will use for
operation.
1In the DISPLAY ACCESS section, press the

[SETUP] key repeatedly to access the SYS-

TEM SETUP screen.

In this screen you can make various settings that affect
the entire LS9.
1WORD CLOCK button
2Move the cursor to the WORD CLOCK but-

ton in the MIXER SETUP field, and press the

[ENTER] key.
The WORD CLOCK popup window will appear,
allowing you to select the clock source on which the
LS9 will operate.

Word clock connection and set-

tings

Digital audio device
+
Clock data
LS9 (word clock slave)
HDR or other digital
audio device (word
clock master)
Slot
Clock data
LS9 (word clock slave)
Digital MTR or other
digital audio device
(word clock master)
Digital audio signal
WORDCLOCK
IN jack
Slot
•The following procedure is not necessary if you are using the LS9
as the word clock master, or if no external devices are digitally
connected to the LS9.
HINT
LS9-32
1
LS9-32