Yamaha LS9-16, LS9-32 Sending signals from MIX channels and STEREO/MONO channels to MATRIX buses

75
Sending signals from MIX channels and STEREO/MONO channels to MATRIX buses
6
Output channel operations
LS9-16/32 Owner’s Manual
This section explains how to send the signal from a MIX channel or STEREO/MONO channel to
MATRIX buses 1–8. You can do this in any of the following three ways.
■Using the SELECTED CHANNEL section• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In this method, you use the SELECTED CHANNEL section [SELECTED SEND] encoder to adjust the level of
the signal sent to the MATRIX bus.
■Using a popup window • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In this method, you use the MATRIX SEND popup window to adjust the send levels from eight channels to a
MATRIX bus.
This method lets you control the send level, on/off setting, and send point for the signals sent from a set of eight
channels to a specific MATRIX bus.
■Using the top panel faders• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In this method, you switch the LS9 to SENDS ON FADER mode and use the top panel faders to adjust the send
levels to the MATRIX bus. This method lets you simultaneously control the send levels and on/off switching for
the signals sent from MIX, STEREO (L/R), and MONO channels to a specific MATRIX bus.
In this method, you use the SELECTED CHANNEL sec-
tion [SELECTED SEND] encoder to adjust the level of
the signal sent to the MATRIX bus.
You can either control the signals sent from a desired
MIX, STEREO (L/R), or MONO channel to all MATRIX
buses, or control the signals sent from all MIX channels to
a specific MATRIX bus.
■Controlling the signals sent from a MIX,
STEREO (L/R), or MONO channel to all
MATRIX buses
1Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1TO MATRIX field
If a MIX, STEREO (L/R), or MONO channel is
selected, this area of the SELECTED CH VIEW
screen will show the TO MATRIX field, allowing you
to switch the on/off status and adjust the send level of
the signals sent to the MATRIX buses.
BTO MATRIX LEVEL knobs
These adjust the send level of the signals sent from the
MIX, STEREO (L/R), or MONO channel to the
MATRIX buses. These knobs are the same color as the
corresponding keys of the MIX/MATRIX SEND sec-
tion.
To adjust the send level in this field, move the cursor to
the knob and use the dial or the [DEC]/[INC] keys. To
switch the on/off status of a signal sent to a MATRIX
bus, move the cursor to the corresponding knob and
press the [ENTER] key.
2Use the LAYER section keys and the chan-
nel module section [SEL] keys to select the
send-source MIX, STEREO (L/R), or MONO
channel.
Sending signals from MIX channels and STEREO/MONO channels
to MATRIX buses
Using the SELECTED CHANNEL sec-
tion
1
2
• In order to select a MONO channel on the LS9-16, you must
first select the custom fader layer to which you’ve assigned
that MONO channel, and then press the corresponding [SEL]
key.
HINT