77
Sending signals from MIX channels and STEREO/MONO channels to MATRIX buses
6
Output channel operations
LS9-16/32 Owner’s Manual
3To adjust the send level from a MIX channel
to the selected MATRIX bus, move the cur-
sor to the corresponding knob of the FROM
MIX field, and operate the [SELECTED
SEND] encoder.
You can obtain the same result by operating the dial or
the [DEC]/[INC] keys.
If the send-destination MATRIX bus is set to stereo,
the send level to the two adjacent odd-numbered/even-
numbered MATRIX buses will be linked.
4To switch the on/off status of a signal sent
from a MIX channel to the selected MATRIX
bus, move the cursor to the corresponding
knob of the FROM MIX field and press the
[ENTER] key.
If you switch this off, the knob will turn grey. To turn
it back on, press the [ENTER] key once again.
5Use the top panel [SEL] keys to switch the
send-destination MATRIX channel and con-
trol the send level to a specific MATRIX bus
in the same way.
Here’s how you can use the MATRIX SEND popup win-
dow to adjust the send levels from up to eight channels to
a MATRIX bus.
1Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1SEND popup button
2Use the LAYER section keys and the chan-
nel module section [SEL] keys to select the
send-source MIX, STEREO (L/R), or MONO
channel.
3Use the MIX/MATRIX SELECT section keys
to select the send-destination MATRIX bus.
Only the LED of the corresponding key will blink,
indicating that it is selected as the send-destination.
4Move the cursor to the SEND popup button
in the screen, and press the [ENTER] key to
access the MATRIX SEND popup window.
In the MATRIX SEND popup window you can view
eight MIX channels or the STEREO (L/R) and MONO
channels at once, and control the send level, on/off sta-
tus, and send point for the signals sent to the MATRIX
bus.
The MATRIX SEND popup window shows the param-
eters for a maximum of eight channels that include the
channel you selected in step 3.
1Channel number / Channel name
This indicates the number and name of the send-
source channel.
BPRE button
This switches the position from which the signal is
sent from the send-source channel to the currently
selected MATRIX bus. If this button is on, the pre-EQ
or pre-fader signal will be sent; if this button is off, the
signal from immediately after the [ON] key will be
sent.
CTO MATRIX ON/OFF button
This is an on/off switch for the signal that is sent from
the send-source channel to the currently selected
MATRIX bus.
DTO MATRIX LEVEL knob
This adjusts the level of the signal that is sent from the
send-source channel to the currently selected
MATRIX bus.

Using a popup window

•When the SELECTED CH VIEW screen for MATRIX channels
is displayed, the keys of the MIX/MATRIX section will operate
as keys that select the send-destination MIX bus for the input
channels.
NOTE
1
3
4
2
1